Thank you for the prompt shipment of the Villers engine to replace it on my Iseki Ks280 tiller.
Attached are photos of the different stages of the modification on the rototiller.
1 - Old engine
2 - Pulley removal
3 - Dismantling the old engine
4 - Cleaning the chassis and fixings
5 - Clean chassis ready to receive the new engine
6 - New engine
7 - Securing the mounting plate and various accessories
8 - motor mounting
9 - Installation of the pulleys and belt; it is impossible to reinstall the pulley housing.
10 - Filling the various oil and fuel tanks
11, 12, 13, 14 - I tested the new engine; it started on the first pull of the starter cord.
15 - problem with the throttle cable return
16 – Adding a small spring and two washers
Thank you for facilitating the installation of the new engine.
And the intelligence officer
Best regards, Yannick
Attached are photos 1 to 16
